Technical Resources

• 2026-01-15 10:13:54

  Do Kytola Flow Meters Need Regular Calibration?

  No. Periodic calibration is unnecessary if the flow meter is used within its intended operating conditions.

• 2026-01-15 10:07:13

  Can a Kytola Flow Meter Be Installed in a Horizontal Pipe?

  The flow meter must always be installed vertically, with flow from bottom to top.

• 2026-01-15 10:04:02

  In Which Applications Can Standard Kytola Gas Flow Meters Be Used?

  Kytola standard air models are designed for normal atmospheric pressure and a temperature of +20°C. They are particularly suited to air-purge applications in which the flow-meter outlet is open to atmospheric pressure at normal room temperature.

• 2026-01-14 14:27:45

  Can Kytola Flow Meters Measure Different Media or Operate Under Conditions Different from Their Nameplate Ratings?

  The flow meter displays the correct reading only when operating conditions match the design values marked on its scale. A conversion factor is required for other operating conditions. Gas flow meter calculation formula. Actual flow rate Q 0 = Actual flow rate ρ 0 = Specific gravity of measured gas (···

• 2026-01-08 15:35:55

  How to Bleed Air from a Lubrication System

  Air must be bled from lubrication lines whenever it is present. Incomplete bleeding can cause abnormal noise, vibration, corrosion and wear, resulting in insufficient or no lubricant delivery, reduced efficiency and possible failure. Six common causes of air entering the lubrication system are: Inco···

• 2026-01-08 15:10:31

  CV Single-cycle Distributor: Structural Overview

  The CV single-cycle distributor, also called a progressive distributor, works with oil or grease in resistance-type lubrication systems. Each outlet has a piston. Lubricant passes the first piston, then the second, and continues sequentially. One complete cycle dispenses lubricant once from every ou···

• 2026-01-08 15:06:14

  Differences Between Oil and Grease Lubrication Systems

  Industrial lubrication systems fall into two main groups according to the lubricant: oil lubrication systems and grease lubrication systems. A comparison table follows for reference: Lubrication system. Lubricating oil （ Rare oil) Grease （ fat) Oil characteristics. Low-viscosity oil has high fluidit···

• 2026-01-08 15:05:50

  Differences Between Resistance-type and Pressure-relief Lubrication Systems

  Details may vary by manufacturer, but the principles are similar. The following table compares the two for reference: Type Resistance-type ( non-metered lubrication) Pressure-relief type ( metered lubrication) Description In resistance-type systems, oil delivery depends on flow resistance: lower res···