Technical Resources

• 2026-01-15 10:43:23

  How to Identify Your KYTOLA Flow Meter Model Code

  The model code is clearly marked on all Kytola products. On Kytola flow meters, the model code is located on the scale, meter body or nameplate. In rare cases the model code may be missing, for example because a component is lost. Please provide detailed pictures and other available information, suc···

• 2026-01-15 10:42:01

  Do Kytola Flow Meters Need Regular Maintenance?

  Under normal conditions, cleaning is the only maintenance required. Clean the exterior of the instrument with soapy water and a soft brush or cloth. Warning: Do not use solvents or alcohol-based cleaners; they may damage flow-meter components. Replace damaged parts immediately.

• 2026-01-15 10:19:09

  Are Spare Parts Available for KYTOLA Products?

  Yes, spare parts are available for all Kytola products. When ordering spare parts, provide the complete model code of the corresponding product.

• 2026-01-15 10:13:54

  Do Kytola Flow Meters Need Regular Calibration?

  No. Periodic calibration is unnecessary if the flow meter is used within its intended operating conditions.

• 2026-01-15 10:07:13

  Can a Kytola Flow Meter Be Installed in a Horizontal Pipe?

  The flow meter must always be installed vertically, with flow from bottom to top.

• 2026-01-15 10:04:02

  In Which Applications Can Standard Kytola Gas Flow Meters Be Used?

  Kytola standard air models are designed for normal atmospheric pressure and a temperature of +20°C. They are particularly suited to air-purge applications in which the flow-meter outlet is open to atmospheric pressure at normal room temperature.

• 2026-01-14 14:27:45

  Can Kytola Flow Meters Measure Different Media or Operate Under Conditions Different from Their Nameplate Ratings?

  The flow meter displays the correct reading only when operating conditions match the design values marked on its scale. A conversion factor is required for other operating conditions. Gas flow meter calculation formula. Actual flow rate Q 0 = Actual flow rate ρ 0 = Specific gravity of measured gas (···

• 2026-01-08 15:35:55

  How to Bleed Air from a Lubrication System

  Air must be bled from lubrication lines whenever it is present. Incomplete bleeding can cause abnormal noise, vibration, corrosion and wear, resulting in insufficient or no lubricant delivery, reduced efficiency and possible failure. Six common causes of air entering the lubrication system are: Inco···